Headlines > News > Curiosity Rover Nearing Yellowknife Bay

Curiosity Rover Nearing Yellowknife Bay

Published by Klaus Schmidt on Tue Dec 11, 2012 11:17 pm via: NASA
Share
More share options
Tools
Tags

PASADENA, Calif. — The NASA Mars rover Curiosity drove 63 feet (19 meters) northeastward early Monday, Dec. 10, approaching a step down into a slightly lower area called “Yellowknife Bay,” where researchers intend to choose a rock to drill.

The drive was Curiosity’s fourth consecutive driving day since leaving a site near an outcrop called “Point Lake,” where it arrived last month. These drives totaled 260 feet (79 meters) and brought the mission’s total odometry to 0.37 mile (598 meters).

This map traces where NASA's Mars rover Curiosity drove between landing at a site subsequently named "Bradbury Landing," and the position reached during the mission's 123rd Martian day, or sol, (Aug. 10, 2012). The inset shows the most recent legs of the trraverse in greater detail. Image credit: NASA/JPL-Caltech/Univ. of Arizona

This map traces where NASA's Mars rover Curiosity drove between landing at a site subsequently named "Bradbury Landing," and the position reached during the mission's 123rd Martian day, or sol, (Aug. 10, 2012). The inset shows the most recent legs of the trraverse in greater detail. Image credit: NASA/JPL-Caltech/Univ. of Arizona

The route took the rover close to an outcrop called “Shaler,” where scientists used Curiosity’s Chemistry and Camera (ChemCam) instrument and Mast Camera (Mastcam) to assess the rock’s composition and observe its layering. Before departure from Point Lake, a fourth sample of dusty sand that the rover had been carrying from the “Rocknest” drift was ingested and analyzed by Curiosity’s Sample Analysis at Mars (SAM) instrument.

Curiosity ended Monday’s drive about 30 percent shorter than planned for the day when it detected a slight difference between two calculations of its tilt, not an immediate risk, but a trigger for software to halt the drive as a precaution. “The rover is traversing across terrain different from where it has driven earlier, and responding differently,” said Rick Welch, mission manager at NASA’s Jet Propulsion Laboratory, Pasadena, Calif. “We’re making progress, though we’re still in the learning phase with this rover, going a little slower on this terrain than we might wish we could.”

The NASA Mars rover Curiosity used its Mast Camera (Mastcam) during the mission's 120th Martian day, or sol (Dec. 7, 2012), to record this view of a rock outcrop informally named "Shaler." Image credit: NASA/JPL-Caltech/MSSS

The NASA Mars rover Curiosity used its Mast Camera (Mastcam) during the mission's 120th Martian day, or sol (Dec. 7, 2012), to record this view of a rock outcrop informally named "Shaler." Image credit: NASA/JPL-Caltech/MSSS

Curiosity is approaching a lip where it will descend about 20 inches (half a meter) to Yellowknife Bay. The rover team is checking carefully for a safe way down. Yellowknife Bay is the temporary destination for first use of Curiosity’s rock-powdering drill, before the mission turns southwestward for driving to its main destination on the slope of Mount Sharp.

JPL, a division of the California Institute of Technology, Pasadena, manages the Mars Science Laboratory Project and the mission’s Curiosity rover for NASA’s Science Mission Directorate, Washington. JPL designed and built the rover.

No comments
Start the ball rolling by posting a comment on this article!
Leave a reply
You must be logged in to post a comment.
© 2014 The International Space Fellowship, developed by Gabitasoft Interactive. All Rights Reserved.  Privacy Policy | Terms of Use