| Page 1 of 1 |
[ 3 posts ] |
Actuators and vanes
| Author | Message |
|---|---|
|
Spaceflight Enthusiast  
Joined: Tue Jul 13, 2004 8:53 pm
Posts: 2 Location: New Zealand 
|
 Actuators and vanes Posted on: Tue Jul 13, 2004 9:06 pmHas Armadillo looked at a more balanced vane offset? Rudders are normally 1/3 leading 2/3 trailing for a balanced rudder with good feel, low force to actuate but avoiding the posibility of being pushed over centre.
What about positive stops as from memory past 30 degrees of movement the blade is more a drag surface than a flow diverter? _________________ Cheers Mark Stacey www.cncprototyping.co.nz |
| Back to top |
  |
|
Spaceflight Trainee 
Joined: Mon Jun 28, 2004 6:05 pm
Posts: 22
|
Posted on: Tue Jul 13, 2004 10:11 pm Did you mean to post this in the Armadillo Q&A thread?
But I believe your questions were all answered in the update posted to their site on Sunday... _________________ - Lars |
| Back to top |
|
|
Spaceflight Enthusiast
Joined: Tue Jul 13, 2004 8:53 pm
Posts: 2 Location: New Zealand
|
Posted on: Sun Jul 18, 2004 9:13 am Yes sheesh too much rush..
Sorry about this stuffup and thanks for the heads up. _________________ Cheers Mark Stacey www.cncprototyping.co.nz |
| Back to top |
|
  |
Page 1 of 1 |
[ 3 posts ] |
Who is online
Users browsing this forum: No registered users and 15 guests |
Gabitasoft Interactive. All Rights Reserved.