Heat shield simulation 4- hypersonic shock boundry layer

Sigma · Posted on: Fri Nov 30, 2012 3:32 am

Heat shield hyper-sonic plasma accelerator test animations for eventually making a physically accurate model of a Hypersonic launch at sea level using the heat shield plasma as a reaction mass and some form of high energy density reactor or beamed power, to reach high orbit without any on-board propellant, the only non reusable section is the heat shield, after one exit/re-entry cycle

Plasma Shock wave simulation
Volumetrics Emission, Particle Fields
http://www.youtube.com/watch?v=wjkJ23QQoMA

Author	Message
Sigma Space Station Member Joined: Mon Dec 12, 2011 6:40 am Posts: 342 Location: California and Michigan	Heat shield simulation 4- hypersonic shock boundry layer Posted on: Fri Nov 30, 2012 12:29 am Heat shield hyper-sonic plasma accelerator test animations for eventually making a physically accurate model of a Hypersonic launch at sea level using the heat shield plasma as a reaction mass and some form of high energy density reactor or beamed power, to reach high orbit without any on-board propellant, the only non reusable section is the heat shield, after one exit/re-entry cycle Plasma Shock wave simulation Volumetrics Emission, Particle Fields http://www.youtube.com/watch?v=wjkJ23QQoMA _________________ Let not the bindings of society hold you back from improving it.... the masses follow where the bold explore.
Back to top

JamesG Space Station Commander Joined: Mon Dec 18, 2006 11:15 pm Posts: 598 Location: Columbus, GA USA	Re: Heat shield simulation 4- hypersonic shock boundry layer Posted on: Fri Nov 30, 2012 3:32 am Couldn't really tell what I was looking at in the video. Is the simulation of the leading edge and so going "downward", gas pressures travelling upward against the plasma?
Back to top
Display posts from previous: Sort by